Children’s Mesh Bed Rail Telescopic Double Pack Setup

By KidCo | Published: 2026-10-18

Category: How-to Guides

Learn how to set up the KidCo Telescopic Mesh Bed Rail double pack quickly and safely, with tips to avoid common mistakes during installation.

Quick answer

Set up the KidCo Telescopic Mesh Bed Rail by sliding it under the mattress, adjusting the telescopic arms to fit the bed width, and tightening the straps for a secure hold. The double pack installs the same way on each side.

Why a telescopic design matters

Telescopic bed rails adjust to different bed widths, so you don’t need to measure or cut anything. The KidCo rail extends to fit most twin and full-size mattresses, making it a flexible option if your child moves to a bigger bed later.

Double pack vs single rail

A double pack covers both sides of the bed, which is useful if the bed is against a wall on one side but your child tends to roll toward the edge. If the bed is already against a wall, a single rail may be enough—but the double pack gives you the option to use both or save one for later.

Step-by-step setup

1. Position the rail under the mattress: Lift the mattress slightly and slide the flat base of the rail between the mattress and box spring. Make sure the rail sits flush against the side of the bed frame. Common mistake: placing the rail on top of the mattress. It must go under the mattress to stay secure.
2. Adjust the telescopic arms: Pull the telescopic arms outward until they reach both edges of the bed frame. The arms should be snug but not forced—overtightening can bend the frame. Check that both arms extend evenly so the rail stays centered.
3. Tighten the straps: Thread the straps through the slots on the rail and around the bed frame or mattress foundation. Pull them tight and fasten the buckle. The rail should not move when you push it. If the straps are loose, the rail can shift during the night. Recheck tightness after the first use.
4. Repeat for the second rail (double pack): Install the second rail on the opposite side of the bed using the same steps. Both rails should be at the same height for a uniform look. Make sure the second rail does not interfere with the first—leave a small gap at the head or foot if needed.
5. Test the setup: Press down on the rail from the inside and outside to confirm it stays in place. Shake the bed gently to simulate movement. If anything shifts, tighten the straps or readjust the arms. A wobbly rail means the arms or straps need adjustment. Never let your child use the bed until the rail is stable.

Product facts

Children’s Mesh Bed Rail Telescopic Double Pack: The KidCo Telescopic Mesh Bed Rail extends to fit various bed widths and uses a mesh barrier for visibility and airflow. You can adjust the rail without tools, and the mesh lets you see your child while keeping the bed ventilated.
Children’s Mesh Bed Rail Telescopic Double Pack